![]() ![]() Be careful though I managed to de-solder some components which i could not put back, but luckily it still worked afterwards. Solder 2 wires to the TX and RX pins on the board, in the attached photo's i have included the pin-out information of the USB Bridge chip. Tip: Borrow your Girlfrien's/Wife's cutex and make a mark on one side of the connector that runs to the OBD2 Connector, that way when you take it out you will know which side it goes because it can go in both ways, for this instructable its not needed to remove the mentioned connector though. Start by removing the sticker on ELM327 Cable's Enclosure, remove the 4 screws with a smallish star screwdriver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |